A Step-by-Step Guide to Tying a Round BalingTwine Baler Twine Using the Baler Knot

Balers refer to either round or square bales that are wrapped using a specific type of knot. The process of wrapping a round or square bale can be complicated for new farmers. But when it comes to seasoned veterans on the field, tying a round BalingTwine baler twine on a baler is pretty easy and straightforward. It’s so easy that you don’t even need to think about it too much. But for the complete newbies, we feel like it’s only right that we show this basic yet essential process. A finished baler knot has either a square or round appearance. The knot tends to tighten as the ends start pulling tight due to the natural pressure that the bales experience. Farmers don’t have to worry about the possibility of it loosening since this knot will negate that from happening.

 

Follow these three simple steps and learn how to tie your square or round bale twine using a baler knot:

 

Step 1: Start the Tying Process

The very first thing to do when tying a balers knot is by holding both ends of the twine. That way, one end will be on one hand while the other purpose is on your other hand. Make sure you have a tight and secure grip so that your bales won’t drop. You will repeat this entire process later on. Also, make sure that your hands are dry and moist-free. Try wearing gloves if you have sweaty palms.

 

Step 2: Begin Tying

When you’re all set, start the BalingTwine baler twine tying process by bending the left rope inwards. Hold it in place before you start bending the right rope towards the inner; and over the top of the left-hand side of the rope. Use the right cord to wrap under and around the left. Once you’ve done the process, start pulling the two ends tight to create a simple criss-cross knot. This motion will form the knot that will tie your bales perfectly in place.

 

Step 3: Finishing Touches

At this point, you’re almost done with your BalingTwine baler twine knot. Start bending the right-hand side of the rope inwards; all while holding the left side in place. Bend the cord towards the inside again and over the top of the left-hand side. Start wrapping the right rope in around and under the left. Afterwards, pull the two tight knots to form another crisscross. At this time, you’ve already created the know and have ensured a tight and unbreakable hold. Congratulations!